Flic IR pinout

poczta

Hi there,
I've accidentaly broken the 2,5mm jack connector to the IR blaster. Can you please state the pinout so I can solder the replacement pin? I'd like to Save myself the trial an error way as there's too many possibilities.

anton

@poczta I don't have an IR in front of me to confirm, but from my notes this should be the pinout (in order):

Tip - Red - 3.3V
Ring - White - RX (IR Wide Receiver)
Ring - Green - TX (IR Blaster PWM)
Sleeve - Black - GND

However, this will be at your own risk. Let me know if you need further info!

Regards,
Anton

poczta

@Emil said in Flic IR pinout:

Do you mean on the IR accessory or the hub itself? Do you have the old Hub or the new Hub LR?

Either the Hub (which color of cable goes to which pin on the connector) or the jack itself (which color f a cable is soldered to which part of a jack).
Something like this:
https://images.app.goo.gl/S5agUKtGewr4LYay6

I've got a new hub.

I'm not exactly sure how I could help you, would you like a photo of how it should look like?

Yes, basically which color of flic IR cable goes to which part of jack /connector. There are four cables inside the wire for IR connector: white, black, green and red.

Could you post a photo of your broken jack?

The jack itself is stuck in the wall (I tried to push it through the hole to my server room). I want to buy a new 2,5 mm jack and solder it to this wires:

Emil

Do you mean on the IR accessory or the hub itself? Do you have the old Hub or the new Hub LR?
I'm not exactly sure how I could help you, would you like a photo of how it should look like?
Could you post a photo of your broken jack?