I am embarrassed to say I overlooked how to do this; I resolve this issue.

@Smellyglove good question. The chip has an internal DC-DC converter so I think will most likely result in the same tx power until depleted. However, when the battery is almost dead there will be much instability and packet losses.

@Emil Hi - someone from flic support replied back to my support case email this morning, so I am good now. Thank you for the response.

This is now resolved.

@Emil understood. Time to get a multimeter then I guess!

This has been solved 😌
See full discussion over at reddit here.

@Emil I see, I didn't think of that! Thanks for your help!

@stenr The bluetooth connection has been transfered to the new phone but cannot be activated. Message: An app is required touse this connection. The Flic app is installed....

@Emil Hey just trying to get an update on this

@joegeiger said in Can I use a flic button for CURT Echo?:

@Emil Thanks for the info! I have all first gen flics. I ordered a new version 2 button to see if it will work. I’ll let you know if it works.

It works! The CURT app paired and is working with the flic 2 button. Thanks for the help.

For other folks finding this as yet unanswered question via a search: FWIW, I have been using magnets on the back of multiple flics for over 6 months now with absolutely no ill effects.

@slbickford THIS still works. Thank you

Same issue here! I also want to figure out a way to toggle the light switch. I'll keep an eye out for any other replies as I am stumped and don't want to go through IFTTT if possible.

@josef_tx sometimes the udp interface of Lifx bulbs seems to stop working. At that time it usually works again if you unplug and replug the power of the bulb. Also, of course make sure it's on the same wifi as the hub. You can also try to re-scan the bulb in the Flic app when connected to the hub.

@info-b Is it possible for you to share the URL so we can test?